| HOME | HELP | FEEDBACK | SUBSCRIPTIONS | ARCHIVE | SEARCH | TABLE OF CONTENTS |
|
|
|
|||||||
|
|||||||||
Department of Earth and Environmental Science and Geophysical Research Center New Mexico Institute of Mining and Technology, Socorro, New Mexico 87801
Department 6116 Sandia National Laboratories, Albuquerque, New Mexico 87185
Department 9236 Sandia National Laboratories, Albuquerque, New Mexico 87185
Abstract
We used a deep (1500 m) cased borehole near the town of Datil in west-central New Mexico to study high-frequency (>1 Hz) seismic noise characteristics. The remote site had very low levels of cultural noise, but strong winds (winter and spring) made the site an excellent candidate to study the effects of wind noise on seismograms. Along with a three-component set of surface sensors (Teledyne Geotech GS-13), a vertical borehole seismometer (GS-28) was deployed at a variety of depths (5, 43, and 85 m) to investigate signal and noise variations. Wind speed was measured with an anemometer. Event-triggered and time-triggered data streams were recorded on a RefTek 72-02 data acquisition system located at the site. Our data show little cultural noise and a strong correlation between wind speed and seismic background noise. The minimum wind speed at which the seismic background noise appears to be influenced varies with depth: 3 m/sec at the surface, 3.5 m/sec at 43 m in depth, and 4 m/sec at 85 m in depth. For wind speed below 3 to 4 m/sec, we observe omni-directional background noise that is coherent at frequencies below 15 Hz. This coherence is destroyed when wind speeds exceed 3 to 4 m/sec. We use a test event (Md 
1.6) and superimposed noise to investigate signal-to-noise ratio (SNR) improvement with sensor depth. For the low Q valley fill of the Datil borehole (DBH) site, we have found that SNR can be improved by as much as 20 to 40 dB between 23 and 55 Hz and 10 to 20 dB between 10 and 20 Hz, by deploying at a 43-m depth rather than at the surface. At the surface, there is little signal above noise in the 23- to 55-Hz frequency band for wind speeds greater than 8 m/sec. Thus, high-frequency signal information that is lost at the surface can be recorded by deploying at the relatively shallow depth of 40 m. Because we observe only minor further reductions in seismic background noise (SBN) at deeper depths, 40 m is likely to be a reasonable deployment depth for other high-frequency-monitoring sites in similar environmental and geologic conditions.
This article has been cited by other articles:
|
|
 |
|
  M. Y. Ali, K. A. Berteussen, J. Small, and B. Barkat A Study of Ambient Noise over an Onshore Oil Field in Abu Dhabi, United Arab Emirates Bulletin of the Seismological Society of America, February 1, 2010; 100(1): 392 - 401. [Abstract] [Full Text] [PDF]
|
|
|
|
|
|
S. J. Arrowsmith, M. A. H. Hedlin, M. D. Arrowsmith, and B. W. Stump Identification of Delay-Fired Mining Explosions Using Seismic Arrays: Application to the PDAR Array in Wyoming, USA Bulletin of the Seismological Society of America, June 1, 2007; 97(3): 989 - 1001. [Abstract] [Full Text] [PDF]
|
|
|
|
|
|
Broadband Seismic Background Noise at Temporary Seismic Stations Observed on a Regional Scale in the Southwestern United States Bulletin of the Seismological Society of America, December 1, 2002; 92(8): 3335 - 3342.
|
|
|
|
|
|
M. Withers, R. Aster, C. Young, J. Beiriger, M. Harris, S. Moore, and J. Trujillo A comparison of select trigger algorithms for automated global seismic phase and event detection Bulletin of the Seismological Society of America, February 1, 1998; 88(1): 95 - 106. [Abstract] [PDF]
|
|
|
|
|
|
C. J. Young, E. P. Chael, M. M. Withers, and R. C. Aster A comparison of the high-frequency (>1 Hz) surface and subsurface noise environment at three sites in the United States Bulletin of the Seismological Society of America, October 1, 1996; 86(5): 1516 - 1528. [Abstract] [PDF]
|
|
| HOME | HELP | FEEDBACK | SUBSCRIPTIONS | ARCHIVE | SEARCH | TABLE OF CONTENTS |
